These brackets are designed to eliminate the bumper gap under the DC5 (facelift) headlight by lifting up the headlight bracket. Over time, your Integra DC5 may experience this bumper sag due to the weight of the front bumper.
To install, a rivet-nut will be required to be inserted into a pre-existing hole on the car as shown in the photos. Simply bolt the plates onto this location. No drilling is required.
Check your car has these holes. This was designed using a JDM/Australian DC5-Type S
All necessary hardware, including bolts, spring washers, and rivet-nut are included.
Note:
JT Spec products are sold for off-road use only. All performance modifications and installations are performed at the customer's own risk. JT Spec holds no responsibility either implied or otherwise for mechanical, electrical, or other failure when using an aftermarket performance product, and expressly denies such responsibility. JT Spec makes no representations and assumes no responsibility for the legality of such items. Products sold for off-road use may be illegal in some states and provinces, and are intended for vehicles which may never be used on a public road.
